Bath Mirror Set, Fog Resistant
1 mirror. 2 sets of medium adhesive strips. Damage-free hanging. Holds strongly in wet conditions. Tested & proven to hold better than suction cups. Water resistant adhesive strips. For questions, ideas and special offers go to command.com. The following statements only apply to products distributed in the USA. Limited Warranty: This 3M product will be free from defects in material and manufacture. If this product is defective, your exclusive remedy shall be, at 3M's option, replacement of the product or refund of the purchase price. Limitation of liability: 3M will not be liable for any loss or damage arising from this product, whether direct, indirect, special, incidental or consequential. Mirror made in China, frame made in Mexico, strips made in USA with US and globally sourced materials.
Contains: Caution: Do not use with wallpaper. May not adhere well to vinyl surfaces. Do not use for antiques, heirlooms, or other valuable or irreplaceable items. Do not hang items over beds.
Remove protective film before use. To Apply: 1. Clean surface with isopropyl rubbing alcohol, let dry. Do not use household cleaners to prep the surface. Separate strips. 2. Press fasteners until they click. 3. Remove one green liner. Position one set of strips on back of mirror, in rectangular zone. Removing remaining green liners. 4. Position mirror on wall. Important: Press each set firmly for 30 seconds to reach maximum holding power. Wait 1 hour before use. Tips: Do not use household cleaners to clean the mirror surface. To Remove: 1. Grab bottom corners and remove mirror as shown. 2. Never pull strip towards you. Strip could break or damage surface if pulled outward. 3. Lightly press top of strip and grab tab. Stretch slowly across the wall. 4. Continue stretching at least 12 inches (30 cm) or until strip releases from wall. Repeat for second strip. Important: Failure to follow instructions carefully may cause damage! Save instructions for damage-free removal or visit command.com. Note: Apply to surfaces above 15 degrees F (-10 degrees C). Adhesive could lose adhesion above 125 degrees F (50 degrees C). Mirror can be reused with medium Command picture hanging strips.